Assembling covers to the Smart Two helmet

 

YAKKAY covers only fit YAKKAY Smart helmets in the same size.

It is important that the back end of the cover is put on the back end of the helmet, and the front end on the front end of the helmet. In all our covers the size tag is placed in the back end, though not necessarily at the exact center point of the back end.

The cover is mounted to the helmet with the elastic band fitted to the helmet’s rim all way around.

Please note, that some covers are quite tight to get to fit to the rim all way around.

The easiest way to mount the cover to the helmet is to start at the back end of the cover (and helmet).

  1. Place the cover in your lap with the back end closest to you.

  2. Put the back end of the helmet into the cover while securing that as much of the elastic band as possible is fitted to the helmet’s rim.

  3. If it is a cap cover, pay special attention to the position of the cap shade.

  4. Press the helmet into the front end of the cover while securing that the elastic band at the back end and the sides of the cover fit close and tight to the helmet’s rim.

  5. At last, make a particular press at the front end of the helmet to get the elastic band to fit close and tight to the helmet’s rim all way around.

  6. Sometimes you will have to move the cover a bit back and forth on the helmet in order to get the elastic band to fit properly all way around.

  7. If the elastic band is not fitted to the helmet’s rim all way around, you may risk that the cover will dismount itself.